Creates a new RouterBgp.
advertiseMode User-specified flag to indicate which mode to use for advertisement.
advertisedGroups User-specified list of prefix groups to advertise in custom mode.
advertisedIpRanges User-specified list of individual IP ranges to advertise in
asn Local BGP Autonomous System Number (ASN). Must be an RFC6996
identifierRange Explicitly specifies a range of valid BGP Identifiers for this Router.
keepaliveInterval The interval in seconds between BGP keepalive messages that are sent
User-specified list of prefix groups to advertise in custom mode.
This field can only be populated if advertiseMode is CUSTOM and
is advertised to all peers of the router. These groups will be
advertised in addition to any specified prefixes. Leave this field
blank to advertise no custom groups.
This enum field has the one valid value: ALL_SUBNETS
User-specified list of individual IP ranges to advertise in
custom mode. This field can only be populated if advertiseMode
is CUSTOM and is advertised to all peers of the router. These IP
ranges will be advertised in addition to any specified groups.
Leave this field blank to advertise no custom IP ranges.
Structure is documented below.
Local BGP Autonomous System Number (ASN). Must be an RFC6996
private ASN, either 16-bit or 32-bit. The value will be fixed for
this router resource. All VPN tunnels that link to this router
will have the same local ASN.
Explicitly specifies a range of valid BGP Identifiers for this Router.
It is provided as a link-local IPv4 range (from 169.254.0.0/16), of
size at least /30, even if the BGP sessions are over IPv6. It must
not overlap with any IPv4 BGP session ranges. Other vendors commonly
call this router ID.
The interval in seconds between BGP keepalive messages that are sent
to the peer. Hold time is three times the interval at which keepalive
messages are sent, and the hold time is the maximum number of seconds
allowed to elapse between successive keepalive messages that BGP
receives from a peer.
BGP will use the smaller of either the local hold time value or the
peer's hold time value as the hold time for the BGP connection
between the two peers. If set, this value must be between 20 and 60.
The default is 20.